Hired-Hand Mega Flow SlantWall Fans: METAL CONE Installation Rev 9-05 - Manual

HIRED-HAND MFG., INC. • 1733 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Manual Part No. 4801-5128 Rev 9-05 Page 1 of 4
Outs
ide E
dge
Insid
e Ed
ge
Arrange panels for assembly
with flat sides down, flange
sides up. The bent tabs of
one panel should contact the
flange of adjacent panel.
Tab before
bending
Bend tab upward
Flange
Tabs
Figure 1
Joints
Mounting
Hole For
Wire guard
Packing List For One (1) Unit Tools Required
Four (4) Cone Sections Four (4) Corner Brackets
One (1) Wire Guard Five (5) 3/8"-16 x 1 Cap Screws
7/16 in. (11 mm) Wrench Ratchet
Sixteen (16) 1/4"-20 Nuts Ten (10) 3/8" Washers
Sixteen (16) ¼"-20 x 3/4" Bolts Five (5) 3/8"-16 Nuts
7/16 in. (11 mm) Socket
Sixteen (16) #14 x 1" TEK Screws Cordless drill and bit
One (1) Installation Manual (For Installing TEK screws)
Marker or Scribe
WARNING!
During Cone Installation Be Sure That Fan Motor Is Not Plugged Into Any Power Source.
Always Double Check Power Sources.
1. Refer to Figure 1. Lay cone pieces flat with their
flanges pointed up.
2. For each panel, bend tabs upward in same direction as
flange. NOTE: Bend tabs by hand. See Inset
Figure 1.
3. Arrange panels with flanges and tabs contacting as
shown in Figure 1. Align holes of flanges and tabs.
Instructions Continued On Next Page
D
!
Assembly & Installation Of Cone
MEGA-FLOW METAL CONE
Installation