Hired-Hand Light Traps: Installing Continuous Light Trap - Manual (Page 2)

Hired-Hand Mfg., Inc. • 1733 County Road 68 • Bremen, Alabama 35033 • Phone 256-287-1000 • Fax 256-287-2000
Sheet Part No. 4801-5501 Rev. 5-08 Page 2 of 6
Installation Instructions
Figure 3 – Assemble Bottom and Sides
Attach Mounting Angles to the Top
and Bottom using four 3/8" x ½" Tek Screws
(1004-0080). See Figure 2.
STEP 1
STEP 2
Attach the Bottoms to the Seal Plate,
aligning the Top of the Mounting Angle to the top of
the Seal Plate. See Figure 3.
STEP 3
Attach Bottom Support Brackets to the
bottom using 1004-2492 tek screws. Support
Brackets should be installed one in middle of bottom
and one on each end centered between adjoining
bottoms. See Figure 3.
STEP 5
Attach sides to bottom at each end of
the Light Trap system using two 1004-0080
Screws per side. Plumb the side and fasten to
the wall using 1004-0054 tek screws for steel
framing or 1004-1386 screws for wood framing.
See Figure 3.
STEP 4
Using a level, level the bottoms and
attach bottom of Bottom Support Bracket to the
knee wall using one 1004-6024 screw per support
arm for concrete or a 1004-1386 for wood. See
Figure 3.
Attach the top to the side using two
1004-0080 Screws. Level the Top and fasten the
Upper Cee using four 1004-0054 tek screws.
Continue running tops for the remainder of the
system leveling each top as installed. See Figure 4.
Figure 2 – Assemble Top & Bottom Mounting Angles
Top or Bottom
Mounting
Angle
Seal Plate
Bottom Support Brackets
attach to kneewall with
TapCon screws.
Figure 4 – Assemble Top
Tek Screw
Tek Screw
STEP 6