Hired-Hand RollSeal Rollup Curtains: RollSeal Motor Controls - Manual (Page 11)

4801-5146 Rev 2-08 Motor Controls Page 10
Reference to Items in Detail A – Remove Limit Switch Cover
Item Description Item Description
1 Drive Unit 15 Hand Crank
2 Output Shaft 16 Not Used
3 Not Used 17 Not Used
4 Copper Sealing Ring 18 Mounting Bore
5 Double Chain 19 Chain
6 Limit Switch Cover 20 Chain Coupling
7 Connector 21 Drive Pipe Shaft
8 Not Used 22 Direction Arrow
9 Terminal Box Cover 23 Not Used
10 Electric Motor 24 Worm Wheel
11 Warning Label 25 Bracket
12 Motor Shaft 26 Not Used
13 Adaptor 27 Not Used
14 Electric Drill 30 Seal
Reference to Items in Detail B – Adjust Limit Switches
Item Description Item Description
1 Switch HII 11 HI Setting Ring Screw
2 Switch HI 12 Setting Ring
3 Not Used 13 HI Setting Ring Screw
4 Terminal Rail 14 HII Setting Ring
5 Not Used 15 HII Setting Ring Screw
6 Not Used 16 HI Setting Ring
7 Not Used 17 HII Setting Ring Screw
8 Setting Ring 18 SII Setting Ring
9 SI Setting Ring Screw 19 SII Setting Ring
10 HI Setting Ring 20 Not Used
To set the Limit Switches, locate the Lock Motor Control
Box. See Detail C. NOTE: Items noted in brackets [ ] in this
section can be found in Detail B.
1. Unscrew the limit Switch Cover and locate the Allen
Wrench and the hex shaft packaged in the Vinyl
Storage Seal. See Detail D.
2. Remove the Vinyl Storage Seal and locate the six
Hex Adjusting Screws on the Ring Screws. See
Detail E.
Limit Switch
Cover
removed
Allen wrench
for adjusting
Limit Switches
Hex shaft for
manually
rotating motor
Vinyl
Storage
Seal
Detail D – Remove Limit Switch Cover
Motor
Detail C – Lock Motor
Limit Switch
Cover