2 unpacking, 1 packaging, 2 unpacking procedure – IEI Integration LCD-KIT Series v2.00 User Manual
Page 52: Npacking

LCD-KIT
Page 42
5.2 Unpacking
5.2.1 Packaging
When shipped, the LCD-KIT series monitor is wrapped in a plastic bag. Two polystyrene
ends are placed on either side of the monitor. The monitor is then placed into a first
(internal) cardboard box. This box is then sealed and placed into a second (external)
cardboard box. The second box is also sealed. A bag containing accessory items is
placed with the monitor in the internal (first) box.
5.2.2 Unpacking Procedure
To unpack the LCD-KIT series monitor, follow the steps below:
WARNING:
The front side LCD screen has a protective plastic cover stuck to the
screen. Only remove the plastic cover after the LCD-KIT series monitor
has been properly installed. This ensures the screen is protected
during the installation process.
Step 1:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
Step 2:
Open the external (second) box.
Step 3:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
Step 4:
Lift the monitor out of the boxes.
Step 5:
Remove both polystyrene ends, one from each side.
Step 6:
Pull the plastic cover off the LCD-KIT series monitor.
Step 7:
Make sure all the components listed in the packing list are present.
Step 0: