IEI Integration AFL-15i-HM55 v1.20 - Manual (Page 60)

AFL-HM55 Series Panel PC
Page 49
3.11.4 VGA Monitor Connection
The AFL-HM55 Series has a single female DB-15 connector on the external peripheral
interface panel. The DB-15 connector is connected to a CRT or VGA monitor. To connect
a monitor to the AFL-HM55 Series, please follow the instructions below.
Step 1: Locate the female DB-15 connector . The location of the female DB-15
connector is shown in Section 1.2.4.
Step 2: Align the VGA connector . Align the male DB-15 connector on the VGA screen
cable with the female DB-15 connector on the external peripheral interface.
Step 3: Insert the VGA connector . Once the connectors are properly aligned with the
insert the male connector from the VGA screen into the female connector on the
AFL-HM55 Series. See Figure 3-28.
Figure 3-28: VGA Connector
Step 4: Secure the connector . Secure the DB-15 VGA connector from the VGA
monitor to the external interface by tightening the two retention screws on either
side of the connector. Step 0: