IEI Integration AFL-15i-HM55 v1.20 - Manual (Page 55)

AFL-HM55 Series Panel PC
Page 44
3.10.3 Arm Mounting
The AFL-HM55 Series is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 75mm or 100mm interface pad. To mount the
AFL-HM55 Series on an arm, please follow the steps below.
Step 1: The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 100 mm interface pad. If the mounting arm is not VESA
compliant it cannot be used to support the AFL-HM55 Series flat panel PC.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat panel
PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
flat panel PC. The AFL-HM55 Series arm mount retention screw holes are
shown in Figure 3-23.
Figure 3-23: Arm Mounting Retention Screw Holes