Figure 3-24: the rack/cabinet bracket – IEI Integration AFL-15i-HM55 v1.20 User Manual

Page 56

AFL-HM55 Series Panel PC

Page 45

Step 4:

Secure the flat panel PC to the interface pad by inserting four retention screws

through the bottom of the mounting arm interface pad and into the flat panel PC.

3.10.4 Cabinet and Rack Installation (15-inch and 17-inch models only)

The AFL-HM55 Series flat panel PC can be installed into a cabinet or rack. The installation

procedures are similar to the panel mounting installation. To do this, please follow the

steps below:

NOTE:

When purchasing the cabinet/rack installation bracket, make sure it is

compatible with both the AFL-HM55 Series flat panel PC and the

rack/cabinet into which the AFL-HM55 Series is installed.

Step 1:

Slide the rear chassis of the AFL-HM55 Series flat panel PC through the

rack/cabinet bracket until the aluminum frame is flush against the front of the

Figure 3-24: The Rack/Cabinet Bracket

Step 2:

Follow the

Step 4 ~ Step 7

in Section 3.10.2 to mount the AFL-HM55 Series

into a cabinet or rack.