IEI Integration PPC-5152-D525 v2.10 - Manual (Page 92)

PPC-5152-D525 Falt-bezel Panel PC
Page 78
Î
IO=3E8h;
IRQ=10, 11
Serial Port I/O port address is 3E8h and the interrupt
address is IRQ10, 11
Î
IO=2E8h;
IRQ=10, 11
Serial Port I/O port address is 2E8h and the interrupt
address is IRQ10, 11
Î Serial Port 3 Mode [RS232]
Use the Serial Port 3 Mode option shows the Serial Port 3 signaling mode is set to
RS-232 and can not be changed. The serial port 3 mode is set by the 10-pin DIP switch on
the motherboard. Please see Section
7
3.11.6.1 for detail.
5.3.5.1.4 Serial Port 4 Configuration
Î Serial Port [Enabled]
Use the Serial Port option to enable or disable the serial port.
Î
Disabled Disable the serial port
Î
Enabled D EFAULT
Enable the serial port
Î Change Settings [Auto]
Use the Change Settings option to change the serial port IO port address and interrupt
address.
Î
Auto D EFAULT
The serial port IO port address and interrupt address
are automatically detected.
Î
IO=2E8h;
IRQ=10
Serial Port I/O port address is 2E8h and the interrupt
address is IRQ10
Î
IO=3E8h;
IRQ=10, 11
Serial Port I/O port address is 3E8h and the interrupt
address is IRQ10, 11
Î
IO=2E8h;
IRQ=10, 11
Serial Port I/O port address is 2E8h and the interrupt
address is IRQ10, 11