IEI Integration PPC-5152-D525 v2.10 - Manual (Page 48)

PPC-5152-D525 Falt-bezel Panel PC
Page 34
3.10.2 Panel Mounting
To mount the PPC-5152-D525 flat panel PC into a panel, please follow the steps below.
Step 1: Select the position in the panel to mount the panel PC.
Step 2: Cut out a section from the panel that corresponds to the dimensions of the flat
panel PC chassis. The panel section that is cut out must be smaller than the size
of the aluminum frame that surrounds the TFT LCD panel but just large enough
for the chassis to fit through. Refer to
556
Figure 3-17 for the suggested cut out size.
Figure 3-17: Suggested Panel Cut Out Size for PPC-5152-D525 (Unit: mm)
Step 3: Slide the flat panel computer through the previously cut hole. The chassis at the
rear of the flat panel should slide easily through the hole. Only stop sliding the
panel through the hole when the back of the front aluminum frame is flush
against the panel.
Step 4: Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the frame. There are a total of 6 panel mounting clamps for
PPC-5152-D525.