IEI Integration PPC-5152-D525 v2.10 - Manual (Page 74)

PPC-5152-D525 Falt-bezel Panel PC
Page 60
Step 3: Remove a total of ten retention screws from the back cover, eight on the rear of
the frame and two on the rear panel (
6
Figure 4-1 ).
Figure 4-1: Back Cover Retention Screws
Step 4: Carefully separate the back cover from the chassis and lift the cover clear of the
device Step 0:
4.5 Replacing Components
4.5.1 Memory Module Replacement
The flat bezel panel PC is preinstalled with a 1.0 GB DDR3 memory module. If the
memory module fails, follow the instructions below to replace the memory module.
Step 1: Follow all anti-static procedures. See Section
6
4.2 .
Step 2: Turn off the power. See Section
6
4.3 .
Step 3: Remove the back cover. See Section
6
4.4 above.
Step 4: Locate the DDR3 SO-DIMM on the motherboard.
Step 5: Remove the DDR3 memory module by pulling both the spring retainer clips
outward from the socket.