Inter-M AOE-212N - Manual (Page 11)

AUDIO OVER ETHERNET
9 AOE-212N
3. Audio Setup
Content Default Value
Mode Setup the audio transmission mode. PCM, uni-cast
Audio Client Setup to receive the audio from another AOE-212N.
Port Setup the connecting port value to receive the audio. 5454
IP Address Setup the IP address to receive the server address audio. 192.168.1.99
Buffer rate The buffer rate is set according to the receiver's network. 3%
Run Check to activate audio receiving.
Audio sever Transmitting audio to other AOE-212N.
Sampling Rate Set the sample rate of the audio signal. 44100
Channels
INPUT CH 1 is selected; the sender channel 1 is
transmitted to the receiver AOE-212N and
is outputted on the receiver's CH1 audio output.
INPUT CH 2 is selected; the sender channel 2
is transmitted to the receiver AOE-212N and is
outputted on the receiver's CH2 audio output.ㅍ
1
Port
Setup the connecting port value to transmit
the port audio.
5454
Sever Address
Set the server address for Multi-cast audio
transmission mode.
224.124.0.1
Run
Sets‘Run’to begin audio transmission.
The equipment list of equipment being sent to the
serial communication serial server run-time will be displayed.
Set
Apply and save the changed contents by using the
button after changing the setup of SET device.
Clear Restore all setups to default values by using button.