Aiwa NSX-MTD9 - Manual (Page 36)

To record with DOLBY NR, turn on NR.
To record without DOLBY NR, turn off NR.
4 Press function (CD,TUNER/BAND,VIDEO/AUX or MD) and prepare the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER/BAND and tune in to a station.
To record from a connected source, press VIDEO/AUX or MD.
5 Press REC/REC MUTE to start recording.
When recording from a connected source, start playback of the source.
When the selected function is CD, playback and recording start simultaneously.
To stop recording, press .
To pause recording, press . (Applicable when the source is TUNER/BAND, VIDEO/AUX or MD.) To resume
recording, press again.
To start recording with the remote control
First press / REC/REC REC MUTE, and then press / within 2 seconds.
SOUND ADJUSTMENT DURING RECORDING
The output volume of the speakers or headphones may be freely varied without affecting the level of the recording.
But BBE and Rhythm play function (BEAT, AUTO SPICE/FILL IN, SPICE A/B) will affect the recording.
Recording with BBE
The desired source can be recorded with the BBE function to enhance the clarity of high-frequency sound. When
playing back a tape recorded with BBE, it is recommended that BBE be set to off.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the Music Sensor function. (Applicable when the source is
TUNER, AUTHOrED.)
1 Press REC/REC MUTE during recording or while in recording pause mode.
on the display flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press to resume recording.
To insert a blank space of less than 4 seconds, press REC/REC MUTE again while is flashing.
To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press REC/REC