INSTEON Wireless Thermostat with Humidity (2441ZTH) Manual - Manual (Page 6)

Page 6 of 27 Rev: 1/21/2014 8:36 AM
• If you set Heat and Cool to the same temperature setpoint, Heat will automatically move
down 2° (the minimum allowable gap).
Energy Button Operation
The Energy button (designated with the leaf) is a quick, efficient energy-saving option. When you press
the Energy button, INSTEON Wireless Thermostat will adjust the Heat and Cool setpoints by a specified
value. The default value is 4° from the current setting, but can be changed via home control software
such as HouseLinc.
• When you exit Energy mode, it will revert back the 4° that was changed upon entry.
• The unit remains in Energy mode until the Energy button is pressed again.
• Up/Down arrows adjust the temperature setpoint based on the mode you are in.
From Off Mode:
• Energy button does nothing because the
system is off (at maximum energy savings
already)
• When “Energy” appears on the screen for
Auto, Cool and Heat Modes, the 4°
setback is engaged
From Heat Mode:
• Heat setback as specified
• Default setback is 4° less
• Notice that “Heating” is active on the left,
but not on the right since the setpoint is
lower that the actual temperature; the
element reads “Heat”
From Cool Mode:
• Cool setback as specified
• Default setback is 4° more
From Auto Mode:
• Both Heat and Cool setpoints changed as
specified
• Default setback is 4° more for Cooling and
4° less for Heating
• Notice that “Heating” is active on the left,
but not on the right since the setpoint is
lower that the actual temperature; the
element reads “Heat”