INSTEON Wireless Thermostat with Humidity (2441ZTH) Manual - Manual (Page 11)

Page 11 of 27 Rev: 1/21/2014 8:36 AM
Optional Accessories
Waterproof Temperature Sensor (2433A3)
INSTEON Waterproof Temperature Sensor is an
external sensor that wires to your INSTEON
Wireless Thermostat. When connected, the
thermostat’s LCD display will show the sensor
readings in small digits above the thermostat’s
temperature.
Waterproof Temperature Sensor can be extended
up to 100’ with 22 AWG wire. It’s ideal for
monitoring and maintaining constant temperatures
in environments like pools, spas, aquariums and
ponds.
Power Supply
INSTEON Wireless Thermostat includes a connection for an AC power supply. Any generic AC/DC
adapter that has a 5-7.5V and 200mA output will work. (
Do not use an adapter greater than 7.5V to avoid
damaging the thermostat .) When connected to external power, INSTEON Wireless Thermostat will
automatically switch from battery power to external power (batteries can remain installed) and will stay on
and awake all the time. If external power is lost, INSTEON Wireless Thermostat will switch back to battery
power. Install power supply as follows:
1) Open the back of INSTEON Wireless Thermostat
2) Locate the wiring block for the power supply. It should be the two left screws.
3) Use a flathead screwdriver to loosen screws
4) Route power supply cable through hole in back of thermostat case
5) Connect power supply’s exposed copper wire strands to terminal block,
making sure the wires are in the correct positive/negative polarities
6) Tighten screws
7) Close back case
INSTEON Wireless Thermostat will automatically turn on and switch to
external power
Installation
CAUTIONS AND WARNINGS
Read and understand these instructions before installing and retain them for future reference.
Preparation
Follow these steps to properly install INSTEON Wireless Thermostat. This thermostat will mainly be used
on a tabletop; wall mounting is optional.
1) Make sure the location that you have selected for INSTEON Wireless Thermostat will not be affected
by daily sun movement or be in direct line of sight of a nearby HVAC vent or fan
2) Insert 2 AA batteries into INSTEON Wireless Thermostat (high quality alkaline batteries
recommended)
3) Close the INSTEON Wireless Thermostat cover