Biamp CI-1 - Manual (Page 5)

5
FRONT PANEL
The CI­1 has three switches on the front panel and an internal (local) sounder, audible through the panel.
Local Sounder
B9)":4;.:"-4+/C)(";4DD)/;)-"?9)/)E)("./A".:.(D",/5+6"();),E)-"./")F6)(/.:"-,=/.:"3(4D"69)"<()"C)6);6,4/")*+,5D)/6@";4/6(4:"./C"
indicating equipment (CIE) or equivalent. It will also commence when any fault is detected. The sounder will continue until the alarm
or fault is reset.
Local Sounder Silence Switch
If the local sounder is operating, this switch may be used to silence it. The alarm or fault condition that caused the sounder to operate is
unaffected by operating this switch. If a new alarm or fault is detected, the sounder will restart. Press and hold the switch for two seconds
to operate.
System Test Switch
B9,-"-?,6;9"?,::",/,6,.6)"."6)-6"-)*+)/;)"4/"69)"01%&'27"#::",/C,;.64(-",/"+-)"4/"69)"01%&'2"?,::":,=96"G(,)HA"./C"69)"-4+/C)(",/"69)"$%&'"?,::"
-4+/C"G(,)HA@"69+-";4/<(D,/="69.6")--)/6,.:".//+/;,.64(-".()"3+/;6,4/.:7"I()--"./C"94:C"69)"-?,6;9"34("6?4"-);4/C-"64",/,6,.6)"69)"6)-6"
sequence.
System Fault Reset Switch
A System Fault denotes that the LSI­16 cannot guarantee correct operation of the Vocia system in an emergency mode. It is indicated on
the LSI­16 and by the sounder in the CI­1. A system fault can only be cleared by operating the System Fault Reset switch. Note that when
the LSI­16 is powered up, the System Fault will be operational until the System Fault Reset switch is pressed. Press and hold the switch
for two seconds to reset a System Fault.