Biamp TEC-1 - Manual (Page 10)

10
TEC-1s INSTALLATION
Surface Mount Installation
The TEC-1s surface mounts to most walls and has a wide variety of mounting holes that accommodate
standard US and international back boxes.
Use a screw driver or other suitable tool to engage the latch at the bottom of the TEC-1s to detach the back
enclosure. When installing the TEC-1s using the RJ45 connector, guide the Ethernet cable through the rear
opening before attaching the TEC-1s to the wall. Connect the RJ45 and snap the front enclosure into the reten-
tion holes. When installing the TEC-1s using the IDC, use a drill bit to create a hole in the top, side, or rear
of the back enclosure along the indentations. Remove the Ethernet cable jacket and shielding.
84mm
3.3"
USA, Japan, Australia EUR
including Germany, Sweden,
UK, Netherlands
60mm
2.36"
Italy
84mm
3.3"
Indentations
Wire here for use with IDC