IPX DDK-1000 - Manual (Page 106)

APPENDIX 6. –FAQ
1. How to disable the DHCP function and use a static IP instead?
A：Turn up the “DIP SWITCH” from “3” to “4” and change the relative network settings, the IP
Address, NetMask and Gateway on the image web page.
2. Can the SD card be removed during recording?
A：No, it cannot be removed until the recording comes to a single point. The POWER LED
flashing light signals the SD card is operating. The green light indicates the unit is activating. The
red light warns the SD card cannot be removed. If the SD card is withdrawn in this mode, the
card will break.
3. I’ve set the function of “Motion Detection” but it doesn’t seem to work.
A：Check if “Motion range” and “Sensitivity” have been set before activating the function.
4. My AVI files recorded in the SD card cannot be displayed. What can I do to display the files?
A：Please visit “http://www.morgan-multimedia.com/” to download “Morgan M-JPEG codec” and
install it, and then check the selection of the “IJP Core”.
5. How to turn on/off the OSD (on screen display) on/off on the Ipxcam?
A：Visit the homepage - tailpage.htm of the device, and select "ON" or "OFF" in the OSD column.
Example: suppose the IP address of the device is 192.168.1.168
Type in http://192.168.1.168/tailpage.htm ( a registration is needed) and select "ON" or "OFF" in
the OSD column.
WARNING: Please write down the IP address of the device before you turn off the OSD.
RMN0100098_v2.0
104