8e6 Technologies Threat Analysis Reporter TAR 1.0 User Manual
Page 19
8
e
6 T
hreaT
a
nalysis
r
eporTer
Q
uick
s
TarT
G
uide
Link the Workstation to the Threat Analysis Reporter
Monitor and Keyboard Setup
A. Connect the PC monitor and keyboard cables to the rear of the chassis.
B. Turn on the PC monitor.
C. Power on the Threat Analysis Reporter unit by dropping down the face plate and
pressing the large button at the right of the front panel (see image below).
Front of the chassis
Once the Threat Analysis Reporter is powered up, proceed to the Step-by-Step Initial
Setup Procedures.
Serial Console Setup
A. Using the serial port cable (and USB DB9 serial adapter, if necessary), connect the
laptop to the rear of the chassis (see images below).
Rear of the “S” or “MSA” chassis
Rear of the “H” chassis
B. Power on the laptop.
C. Power on the Threat Analysis Reporter by dropping down the face plate and pressing
the large button at the right of the front panel (see top image on this page).
Once the Threat Analysis Reporter is powered up, proceed to the instructions for Hyper-
Terminal Setup Procedures.