Yamaha MCR-E810 - Manual (Page 52)

48
En
Controlling External Components
You can control TVs made by other manufactures by
setting the appropriate remote control code (refer to “LIST
OF REMOTE CONTROL CODES” at the end of this
manual). Follow the procedures below to set the remote
control code.
1
Press AUX/TV to set the remote control to the
AUX/TV mode.
2
While holding down PROG , press AUX/TV,
and then use the number keys to enter the
three-digit remote control code (refer to
“LIST OF REMOTE CONTROL CODES” at the
end of this manual) for the manufacturer of
your TV.
3
See “AUX/TV mode” on page 46 and try one
of the key operations for your TV to check
that the setting is working properly.
If the key operation does not work properly, the
remote control code may be incorrect. In this case,
perform step 2 again.
• Even if you set a remote control code, it will be cleared about
two minutes after the remote control batteries run out. In this
case, store remote control codes again after replacing the
batteries. (Be careful not to press the remote control keys while
replacing the batteries. Doing so may clear the settings.)
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
Setting remote control codes
STANDBY/ON POWER
TV
1 2 3 4
5 6
9 0
7 8
SCAN DIMMER
A-B
PROG
SHUFFLE TV INPUT
ON SCREEN MENU PRESET
ENTER A-E
DISPLAY
SLEEP
DVD/CD TUNER BAND
TAPE/MD
SUBTITLE ANGLE ZOOM AUDIO
AUX/TV DOCK
A-E
INFO.
SET UP
TV VOL VOLUME
TOP MENU
/RETURN
TV CH
REPEAT
FREQ/TEXT
PTY SEEK MODE START
AUX/TV
PROG
Number
keys
Notes