Yamaha MCR-E810 - Manual (Page 23)

SETTING THE SYSTEM
19
En
Eng
lish
PREP
ARA
TION
Before starting playback operation, follow the procedure below to configure the system settings.
1
Turn on your TV and then press STANDBY/
ON to turn on the receiver.
If the DVD player is connected to the receiver with
the system control cable, the DVD player turns on
automatically. Otherwise, press STANDBY/ON on
the front panel of the DVD player to turn on it.
The front panel display of each component lights up.
2
Press DVD/CD to select “DVD/CD” as an
input source.
3
On your TV, select the input to which the DVD
player is connected (EXT1, AV1, etc.). For
details, refer to the manual supplied with
your TV.
The default screen appears on the TV screen.
If the picture is distorted on your TV, the color system (NTSC and
PAL) setting of the DVD player may not match your TV.
To switch the color system setting in such case, press and then
AUDIO while the disc tray is open.
1
Press DISPLAY on the front panel of the
receiver.
“Clock Time” appears in the front panel display for a
few seconds, and then “Set Clock” appears.
2
Press TIME ADJ for about two seconds to
enter the clock setting mode.
3
To set the hour setting ahead, press HOUR
repeatedly. To set the hour setting backward,
press HOUR repeatedly while holding down
PRESET/BAND.
4
To set the minute setting ahead, press MIN
repeatedly. To set the minute setting
backward, press MIN repeatedly while
holding down PRESET/BAND.
Setting the System
Step 1: Turn on the power and
select the DVD input
Note
STANDBY/ON POWER
TV
1 2 3 4
5 6
9 0
7 8
SCAN DIMMER
A B REPEAT SLEEP
DVD/CD TUNER BAND
TAPE/MD
SUBTITLE ANGLE ZOOM AUDIO
AUX/TV DOCK
STANDBY/ON
DVD/CD
Step 2: Adjust the clock
MIN MAX
VOLUME
INPUT BALANCE
L R
TREBLE BASS
PHONES
STANDBY/ON
TIMER DISPLAY MEMORY
NATURAL SOUND STEREO RECEIVER RX-E810
PRESET/BAND PRESET/TUNING
PURE DIRECT
HOUR TIMER TIME ADJ MIN
AUTO/MAN'L
DISPLAY HOUR MIN
TIME ADJ PRESET/BAND