Optiview Enterprise Series - Manual (Page 7)

- 6 -
2.8 Set IP Information on the DVS
Values shown here is only an example. Follow the IP address scheme on your own
Local Area Network (LAN). Consult your local IT staff or your Internet Service Provider
as to what IP address information you are going to use on this task.
To Set IP Address, Subnet Mask, Default Gateway and Port

setIp 192.168.1.200:255.255.255.0

setGateway 192.168.1.1

setPort 5000

exit
Close the Hyper-terminal program and restart the Video server after the settings has
been set up.
3. Configure the IP Video Server through Remote Client Software
3.1 You can use these default IP settings as a starting point to connect them to your
local PC and reset these IP settings by using Remote Client software to change IP
information that will work for your own local network.
1.1.1 Change the IP information of your local PC used to configure the Wireless
IP kit. Your PC IP address should be within the same range as that of the
Wireless IP Kit. You local PC must be connected to the same router/hub
where the Wireless IP kit is also connected.
1.1.2 Make sure you have excellent network connectivity between the local PC
and the Wireless IP Kit. On your local PC,
Step1
step 2
Step 3: Type the command
ping followed by IP address of the IP video server.
(Note: The IP address shown here is an example only and may or may not be your
actual IP address).