Optiview Enterprise Series User Manual
Page 4
- 3 -
II.
Installation of the Device
1. Simple Block Diagram of the Digital Video Server
2. Configuring IP Settings through the Hyper-terminal connection
2.1 Connect the RJ45-to-DB9 connector to the Video Server.
The DB9 goes into the Serial port COM1 on a PC, while the RJ45 connector goes into
the RS232 port on the DVS (Digital Video Server). Com port may not always be COM1
on a PC. Please check with your local PC configuration for correct selection of COM
port.
2.2 Turn ON the Video Server, and press the Reset Switch at the front panel. Turn
OFF/ON the DVS again. Skip this step if your unit does not have a reset switch.
DB9 Connector to go to PC Serial Port
RJ45 connector to go to RS232
port of the Video Server