Radio Shack PRO-2067 - Manual (Page 52)

52
RESETTING/
INITIALIZING THE
SCANNER
You might need to reset or initialize
the scanner if:
• the scanner’s display locks up.
• the scanner does not work prop-
erly after you connect power.
• the scanner is dropped or sub-
jected to a physical or electrical
shock.
Important: If you have problems, first
try to reset the scanner. If that does
not work, you can initialize the scan-
ner; however, this clears all informa-
tion stored in your scanner’s memory.
Resetting the Scanner
1. Turn off the scanner, then turn it
on again. Welcome To Multi-
System Trunking appears.
2. Insert a pointed object, such as a
straightened paper clip, into the
reset hole on the back of the
scanner. Then gently press and
release the reset button inside the
opening.
Note: Pressing the reset button does
not clear the scanner’s memory.
Initializing the Scanner
Important: This procedure clears all
the information you have programmed
into the scanner. Use this procedure
only when you are sure your scanner
is not working properly.
To initialize the scanner, turn off the
scanner then turn it on again. Then,
while
Welcome To Multi-System
Trunking appears, press 0 then 1 .
Please Wait. appears for about 25
seconds, then Welcome To Multi-
System Trunking appears again
Important: Do not turn off the scanner
until
Welcome To Multi-System
Trunking appears again.
20-196a.fm Page 52 Friday, June 2, 2000 3:48 PM