Radio Shack 20-164 - Manual (Page 15)

28
Searching
29
Searching
2. Press S or T. “Sp. Stalker” appears for
Special Signal Stalker II.
3. To turn off Special Signal Stalker II, press
FUNC and then S or T again.
Locking Out Frequencies
When you lock out frequencies during a search,
the scanner continues searching, but ignores
the locked out frequencies. You can lock out
up to 50 frequencies in each bank. If you try to
lock out more,
“L/O Memory Full!” appears.
While using Signal Stalker II, you can lock out
150 frequencies if searching All Bands and
50 frequencies while searching PubSafety
frequencies. If you lock out 5 frequencies
within a 1 MHz segment, the scanner will skip
that segment in subsequent sweeps.
Notes:
• If you lock out all the frequencies in a
search bank and only that search bank is
activated, “
All ranges Locked out!”
appears and the scanner does not search.
• Signal Stalker II still performs a fine step
search for locked out signals. Signal
Stalker II will not stop on the signal, but
scan may take longer.
To lock out a frequency:
When the scanner stops on a frequency, press
L/OUT.
To review and unlock frequencies:
1.
Press SRCH to enter search mode.
2. Press FUNC then L/OUT. The first locked-
out frequency and lockout list appear.
If the search bank has no locked-out
frequencies,
“No Lockout” appears.
3. Press S or T to review the list. The
current position and the total locked-out
number also appear as
“Lockout XX of
YY.” (Example: Lockout 10 of 30.)
4. (Optional) To unlock a frequency, select
the frequency then press CLEAR.
5. Press FUNC then L/OUT again to exit.
To unlock all frequencies in a search bank:
1. Press SRCH.
2. Select the search bank.
3. Press FUNC then press L/OUT. The
Lockout list appears.
4. Press FUNC then 6. “Clear entire
list?” appears.
5. Press 1. “List cleared” appears.
Pressing any other key cancels the
clearing.
Saving Found Frequencies
To save a frequency found during a search:
1. When the scanner stops on a frequency,
press FUNC then PROG.
“Store in
ChXXX?” appears and the frequency
flashes.
2. To change the target channel, enter the
bank and channel number.
3. Press ENT. “Channel Stored!” appears
briefly, then the search resumes.