Radio Shack 20-164 - Manual (Page 12)

22
Setup
23
Searching
To clone the scanner data:
1. Turn on both scanners.
2. Connect the connecting cable to each
scanner’s PC/IF jack.
** CLONE MODE **
appears.
3. Press S. “Confirm to send data?”
appears.
4. Press 1 to send the data to the other unit
or press any other key to cancel.
5. To exit the clone mode, remove the cable.
Note: “CLONE MODE Incorrect
Model” appears if you connect a scanner
other than a PRO-164 or PRO-163.
Searching
You can search for transmissions using the
preprogrammed search bank, which is divided
into eight search bands.
Seek Search
When Seek Search is active, the scanner stops
on active frequencies for five seconds and
then resumes searching automatically.
To activate Seek Search:
1. Press FUNC then 7. “Seek Search ON”
appears briefly and S appears on the
display.
2. To turn off Seek Search, press FUNC then
7 again.
“Seek Search OFF” appears
briefly.
Search Banks
To search preprogrammed search banks:
1. Press SRCH repeatedly to select a bank.
Bank Band Freq. Chart
SR0 Marine Page 61
SR1 CB Page 62
SR2 FRS/GMRS/MURS Page 62
SR3 Public Safety Page 63
SR4 Aircraft Page 65
SR5 Amateur Bands Page 65
SR6 Railroad Page 65
SR7 Limit search (User change-
able)