National Instruments PC-DIO-24/PnP - Manual (Page 90)

Appendix D Using Your PC-DIO-24 (Non-PnP) Board
© National Instruments Corporation D-7 PC-DIO-24/PnP User Manual
The PC-DIO-24 uses a tristate driver to drive its selected interrupt line.
The PC-DIO-24 can therefore share an interrupt line if your system and
your other devices allow.
Installation
Install the PC-DIO-24 as described in Chapter 2, Installation and
Configuration.
If you have an ISA-class computer and you are using a configurable
software package, such as NI-DAQ, you may need to reconfigure your
software to reflect any changes in jumper or switch settings. If you have
an EISA-class computer, you need to update the computer resource
allocation (or configuration) table by reconfiguring your computer. See
your computer user manual for information about updating the
configuration table.