Nortel Networks Remote Gateway 50 User Manual
Page 191
Dialing Plan configuration
Page 191 of 258
Main Office Configuration for Survivable Remote Gateway 50
Configuration Guide
After configuring the specialized route for calls that have been routed
to the branch office by the NRS, the route must be associated with
the ESN Special Number.
The branch office receives the manipulated number as an incoming
call, indicating that the ZDP value added at the main office is at the
beginning of the number. The branch office ESN configuration must
ensure that the extra digits (the ZDP value) are deleted by using a
proper DMI. The call then terminates at the PSTN connection.
Note: The DMI configured in LD 86 in step 1 on
is used to
remove the digits that were inserted in the dialed number at the main
office.
For example, assume ZDP at the main office = 101, Customer
number = 0, and the RLI for the PSTN trunk = 18.
c.
>LD
90
REQ
NEW
CUST 0
FEAT NET
TRAN AC1
TYPE SPN
SPN
1011
FLEN 0
...
RLI
18
- FLEN
(0)-24
Flexible Length
The number of digits the system expects to receive before
accessing a trunk and outpulsing these digits.
...
- RLI
0-999
Route List Index configured in LD 86 (see step 1 on
)
LD 90 – Configure ESN Special Number and Digit Manipulation. (Part 2 of 2)
Prompt
Response
Description