Panasonic PV-V4525S - Manual (Page 23)

On-Screen Displays (OSD)
VCR Status & Clock Displays
Function & Channel Displays Blank Tape/
No Video Signal Indications
When blank tape is detected during play, or
the current channel has no signal (with Weak
Signal Display feature (p. 10) set to OFF), the
TV screen will turn solid blue.
CH 0 8
When a function button is
pressed, e.g. PLAY, or you
change channels,
a 5 second display
appears.
To display or remove
overlay at right,
➛ press DISPLAY*.
On-Screen Displays (OSD)
These displays will alert you to a missed operation or
provide further instructions.
OSD Caution Page
PLEASE SET CLOCK BY
PRESSING ACTION KEY If you attempt to set or review a Timer
Recording and the Clock is not set...
After a Timer Program has been set...
If you press REC on the remote
control or VCR, and a cassette is
inserted with no record tab...
If you press PLAY, FF, REW, or REC on
the remote control or VCR without a
cassette inserted...
CHECK CASSETTE
RECORD TAB
NO CASSETTE
TURN VCR OFF
FOR TIMER RECORDING
If you press POWER or STOP during
a Timer Recording...
(visible in VCR mode only) TO CANCEL TIMER REC
PRESS POWER THEN
STOP KEY
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OR REFER TO MANUAL
END :PLAY
VCR LOCK ACTIVATED
If head cleaning becomes necessary
while playing back a tape...
If you press a function button other
than STOP/EJECT or POWER while
the VCR is in VCR Lock mode...
Warning and Instruction Displays
See page 6 of Basic
Operations book
See page 6 of Basic
Operations book
See page 3 of Basic
Operations book
See page 5 of Basic
Operations book
See page 6 of Basic
Operations book
See page 3 of Basic
Operations book
See page 10
- 11 -
REC 12 : 0 0AM
0 : 25
CH 02
-0 : 12 : 34
SP STEREO
SAP
MONO
Function Status
Rec Time Remaining
(OTR mode only.
See p. 5 of Basic
Operations book.)
Current Time
Channel
Tape Speed
(See p. 3 of Basic
Operations book.)
Broadcast Audio
Being Received
Counter
*Important: If a remote control button does not work when pressed,
press the VCR button on the remote and try the button again.