Kohler Power Systems 14/20RESA - Manual (Page 17)

TP-6804 12/11 17 Section 1 Descriptions and Service Views
DC2 Controller Features
D Four-button keypad: OFF, AUTO, RUN, and
EXERCISE pushbuttons
D LED indicators for OFF, AUTO, and RUN modes
D LCD display:
d Two lines x 16 characters per line
d Backlit display with adjustable contrast for
excellent visibility
D Scrolling system status display
d Generator set status
d Voltage and frequency
d Engine temperature
d Oil pressure
d Battery voltage
d Engine runtime hours
d Maintenance reminders
d OnCue status (connected/disconnected)
D Date and time displays
D Smart engine cooldown senses engine temperature
D Digital isochronous governor to maintain
steady-state speed at all loads
D Digital voltage regulation:
±0.5% RMS no-load to
full-load
D Automatic start with programmed cranking cycle
D Exercise modes
d Unloaded weekly exercise with complete system
diagnostics
d Unloaded full-speed exercise
d Loaded full-speed exercise (Model RXT ATS
required)
D Front-access mini USB connector for SiteTech t
connection
D Front access mini-breaker protects the alternator
D Integral Ethernet connector for Kohler r OnCuet
D Built-in 2.5 amp battery charger
D Remote two-wire start/stop capability for optional
connection of Model RDT or RSB transfer switches
D Diagnostic messages
d Displays diagnostic messages for the engine,
generator set, model RXT transfer switch, and
optional programmable interface module (PIM)
and load control module (LCM)
d Over 70 diagnostic messages can be displayed
D A laptop computer and Kohler r SiteTech software
can be used to change system settings or upgrade
controller firmware.