Kawai Professional Stage Piano MP8II - Manual (Page 38)

38
6.2.19 Transmitting Volume (Ext only)
This parameter determines if an initial MIDI Volume message will be transmitted
(On) to an external MIDI device or not (Off) when a SETUP is recalled.
Note:
In a zone set to External or Both, moving the faders will still transmit volume
messages even if TX Volume is set to Off.
6.2.20 Volume
This parameter sets the volume level for the selected zone. The value can be
changed by using the FADER or VALUE buttons.
For External zones, when the TX Volume is “Off”, this page won’t be displayed.
6.2.21 Transmitting Control Change (Ext only)
This parameter determines if the Pan/Fine Tune/Control Knob settings will be
transmitted (On) via MIDI or not (Off) when a SETUP is recalled.
Note:
In a zone set to External or Both, moving the Control Knobs will still transmit
the values even if TX CC is set to Off.
6.2.22 Pan
Int: This sets the pan-pot (right and left balance).
Ext: This sets the pan-pot value that will be transmitted to external sound modules.
If the TX CC is “On”, the value is transmitted when a SETUP is recalled. When
the TX CC is “Off”, this page won’t be displayed.
The value changes from L63 to R63.
6.2.23 Fine Tune
Int: This is a fine tuning function for values smaller than a semi-tone.
Ext: This is used to transmit fine tuning settings to external sound modules. If the
TX CC is “On”, the value is transmitted when a SETUP is recalled. When the
TX CC is “Off”, this page won’t be displayed.
The value changes from -63 to +63.
6.2.24 Damper
This parameter determines if the damper pedal is active (Norm [Int] / On [Ext],
with natural decay), deactivated (Off) or set to HOLD (On, with steady sustain
level) for the selected zone.
Use the HOLD value, if you don’t want a sound to disappear. HOLD is only
available for internal Sounds.