Socket Mobile 56K Modem Card - Manual (Page 31)

CHAPTER 2: SETUP FOR WINDOWS CE | 31
Handheld PC Devices
1. After setting up the dial-up connection in Step 5, you will already be in
the Dial-Up Connection screen.
To access this screen at any time, follow these steps:
• Go to Start | Programs | Communication | Remote Networking.
• Tap on the icon for the modem connection you created in Step 5.
2. In the next screen, verify the connection information.
3. For some mobile computers, you must modify the dial properties. For
instructions, refer to the mobile computer’s user manual.
4. Tap Connect. Call status screens will appear, and the Power and Data
Status LEDs will blink.
5. After the status screen reports that you have Connected, two connection
icons will appear:
Connection icon: (Task tray at bottom of screen)
Indicates an active dial-up or network connection
Modem status icon: (Task tray at bottom of screen)
GREEN — connected RED — data transmitting
When the HPC is connected, the Link and Power Status LEDs will stay
on, and the Data Status LED will blink during data transmission.
Ending a Data Call
1. Tap on the connection icon in the task tray:
2. In the status screen, tap Disconnect. After the mobile computer disconnects,
the task tray icon will disappear from your screen. All LEDs may turn off,
depending on your device.