Sony HM-982RW - Manual (Page 62)

62
Preparation section
Basic section
Application section
Knowledge section
Convenient recording of CD player output
2
1
1 Place a recordable CD-R or CD-RW disc. fl
2 Load the recording source disc in the CD player.
¢
3 Make sure that the "High" (high-speed dubbing
indicator) in the display is not lit.
Make the preparations for recording.
Check the current play mode of the CD player.
Select the “CD” input. Be sure to put the CD recorder in stop mode.
The Twin Recording makes is possible to record desired CD tracks programmed in the desired order onto a CD-R/RW
simultaneously. (High-speed recording is not available.)
The recording source can be a finalized CD-R/RW, but digital-to-digital recording may not be available with certain
discs.”Digital recording and SCMS”
A
Program recording
(PGM mode + O.T.E.) (Norm)
Start recording.
÷ High-speed recording is not available in the PGM mode.
÷ Recording starts with the first programmed track until all the
programmed tracks have been recorded.
÷ When either the CD program playback or CDR recording
operation stops, the other operation also stops.
÷ When you are operating the main unit, select "O.T.E. Mode"
in the menu mode, then select "CD = = = = =CDR " and
press the SET key to start recording.
÷ With certain discs, digital-to-digital recording may be prohib-
ited by SCMS ( A). Such a disc should be recorded using
the analog output signal.
e
Program the desired sequence of CD tracks.
4
3
If it is in play mode, stop it.
Perform steps
2 and 3 of the procedure in ”Lis-
tening in the desired sequence (Program play-
back)”.
u
CD =CDR
DIGITAL
When digital-to-digital recording is not impossible
or when analog-to-digital recording is performed,
select the analog input as described in the follow-
ing section then start the setting from step
1
below.”Changing the recording input setting” e
7
Before recording
÷ When a CD-R/RW is loaded in the CD recorder, the CD-R IN
indicator may blink for a while.
“OPC (Optimum Power Control)” ‡
÷ If the "HIGH" is lit in the display, turn it on by selecting "O.T.E.
Speed" in the menu mode, selecting "" and press-
ing the SET key.
The current setting is displayed.
"DIGITAL" is lit ............. Digital-to-digital recording
"DIGITAL" not lit: ......... Analog-to-digital recording
CD CDR
=