Adjusting the height of the center mount footrest – Invacare Van Seat PHWH93 User Manual

Page 23

SECTION 6—FRONT RIGGINGS

Adjusting the Height of the Center Mount Footrest

ƽ WARNING

While the wheelchair is moving, minimum ground clearance for the front rigging is

three inches. If the wheelchair is not moving, the front rigging MUST maintain a

minimum of one inch ground clearance - otherwise personal injury and damage may

result.

NOTE: For this procedure, refer to FIGURE 6.8.

1. Remove the two mounting screws that secure the footrest extension tube to the

extension tube housing.

2. Adjust the footrest extension tube to the desired height and align the corresponding

holes to the mounting holes on the extension tube housing.

3. Reinstall the two mounting screws to secure the footrest extension tube to the

extension tube housing. Securely tighten.

4. Repeat STEPS 1‐3 for the other extension tube.

FIGURE 6.8 Adjusting the Height of the Center Mount Footrest

Seat Frame

Extension

Housing

Extension Tube

Height Adjustment

Holes

Mounting Screws

Extension Tube Mounting Holes

NOTE: Release Lever
located towards the front or
center of seat frame.