Removing, Adjusting footrest height, Model phwh93 – Invacare Van Seat PHWH93 User Manual
Page 18: Model ph904a and phal4a

SECTION 6—FRONT RIGGINGS
18
Removing
1. Push the front rigging release lever inward and rotate the footrest out.
2. Lift up on front rigging and remove from the wheelchair.
3. Repeat STEPS 1‐2 for opposite side of wheelchair.
Adjusting Footrest Height
Model PHWH93
NOTE: For this procedure, refer to FIGURE 6.2.
1. Remove any accessories from the footrest(s).
2. Remove the footrest from the
wheelchair. Refer to Installing/
Removing Front Riggings on page 17.
NOTE: Lay footrest on a flat surface to simplify
section.
3. Remove the hex bolt, coved washers
and locknut that secure the lower
footrest to the footrest support.
4. Reposition the lower footrest to the
desired height.
5. Reinstall hex bolt, coved washers and
locknut that secure lower footrest to
footrest support. Tighten securely.
FIGURE 6.2 Adjusting Footrest Height -
6. Repeat STEPS 1‐5 for the opposite side of the wheelchair footrest, if necessary.
7. Reinstall the footrest(s) onto the wheelchair. Refer to Installing/Removing Front
8. Reinstall any accessories onto the footrest(s).
Model PH904A and PHAL4A
NOTE: For this procedure, refer to
FIGURE 6.3.
NOTE: PH904A style front rigging shown.
PHAL4A front rigging adjust the same way.
1. Loosen, but do not remove the lug bolt
and locknut that secure the lower
footrest to the footrest support.
2. Reposition the lower footrest to the
desired height.
FIGURE 6.3 Adjusting Footrest Height -
Coved Washer
Hex Bolt
Footrest
Support
Coved
Washer
Locknut
Lower
Footrest
Locknut
Footrest
Support
Lower
Footrest
Lug Bolt