Replacing heel loops, Raising/lowering elevating front riggings – Invacare Van Seat PHWH93 User Manual

Page 19

SECTION 6—FRONT RIGGINGS

3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest

support.

4. Repeat STEPS 1‐3 for the opposite side of the wheelchair footrest, if necessary.

Replacing Heel Loops

NOTE: For this procedure, refer to FIGURE 6.4.

1. Note the position of hex bolt, coved

washers and locknut for reinstallation.

2. Remove the hex bolt, coved washers

and locknut that secure the lower
footrest to the footrest support.

3. Remove the lower footrest.

4. Remove the phillips bolt, spacer and

locknut that secure the existing heel
loop to the lower footrest.

5. Slide the existing heel loop off the

lower footrest.

6. Replace heel loop.

7. Reverse STEPS 1‐6 to reassemble.

FIGURE 6.4 Replacing Heel Loops

NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the
spacer is secure.

Raising/Lowering Elevating Front Riggings

NOTE: For this procedure, refer to FIGURE 6.5.

1. Perform one of the following:

• Raising ‐ Pull back on the release lever and raise front rigging to the desired height.

• Lowering ‐ Support front rigging with one hand away from the release lever. Push

release lever downward with other hand.

FIGURE 6.5 Raising/Lowering Elevating Front Riggings

Coved

Washer

Hex Bolt

Footrest

Support

Coved

Washer

Locknut

Lower

Footrest

Phillips Bolt

Locknut

Spacer

Heel Loop

Release

Lever