I-Data 812-1x MIO - Manual (Page 30)

ida 812-1x MIO Operator’s Guide
Errors and Recovery
-30-
6. Errors and Recovery
6.1. Error Messages in MIO front panel
The 80_service (01XX) error message will be displayed in the
MIO front panel if the following error situations occur:
Recovery attempt can be made as follows:
•
Turn power off for 10 seconds and then on again. If the
problem persists, contact technical assistance.
DESCRIPTION XX CAUSED BY RECOVERY
Firmware check
sum error 61 Comes at power on after
interrupted download of
firmware Download
firmware again
Flash prom error 71 Flash prom used by
firmware damaged Install new flash
prom
Flash prom error 72 Flash prom used by
firmware damaged Install new flash
prom
Line interface RAM
ERROR 81 Hardware error
Wrong data in self
test 82 Hardware error
Wrong word in self
test 83 Hardware error
Response missing
from Twinax
interface 84 Hardware error
Wrong interrupt
from Twinax
interface 85 Hardware error
No test response
from Twinax
interface 86 Hardware error
Invalid test
response 87 Hardware error
Nothing received in
self test 8A Hardware error
Forced download 8B Hardware error
End of flash
program 8C Download of firmware
finished successfully
Error in HEX data 8D An error has occurred
when firmware was
Power OFF and
ON and download