beautypg.com

Installation procedure, Hp laserjet iiisi and 4si, Hp laserjet 4v – I-Data 812-1x MIO User Manual

Page 12

background image

ida 812-1x MIO Operator’s Guide
Installation

-12-

2.3. Installation Procedure

The installation of the ida 812-1x MIO interface varies slightly
depending on the printer in which it is installed. This is decribed in
more detail below.

NOTE:
Irrespective of printer, you should first make sure
that power to the printer is turned OFF, and that
the correct language has been selected on the
interface DIP switch bank as described in
Section 2.1, DIP Switch Language Selection
and
illustrated in Appendix B, DIP Switch Settings
.

2.3.1. HP LaserJet IIISi and 4Si

1. Remove the HP MIO (Modular Input/Output) card from the

bottom slot on the rear of the printer by loosening the screws
and pulling the card out of the printer.

2. Insert the ida 812-1x MIO interface (twinax connector at the

bottom) in place of the card you just removed and tighten screws.

2.3.2. HP LaserJet 4, HP LaserJet 4 Plus

and HP LaserJet 5

1. Loosen the screws on the cover plate positioned to the left of

the parallel and serial connection (on the rear panel) and
remove the plate.

2. Insert the ida 812-1x MIO interface (twinax connector at the top)

in the slot and tighten screws.

2.3.3. HP LaserJet 4V

1. Loosen the screws and remove the plate positioned on the rear

of the printer.

2. Insert the ida 812-1x MIO interface (twinax connector to the

right) in the slot and tighten screws.