IBM Partner Pavilion 1464 - Manual (Page 21)

21
Install memory, firmware, or option cards
Installing a memory card
Follow the instructions in this section to install a printer memory card. Memory cards
must have 168-pin connectors.
Note: Some memory options offered for
other printers cannot be used with your
printer. Refer to the publications CD for
memory specifications.
1 Remove the system board access cover (see page 20).
Warning: Memory cards are easily
damaged by static electricity. Touch
something metal on the printer before
you touch a card.
2 Unpack the memory card.
Avoid touching the connection points along the edge of the card. Save the
packaging.
3 Push open the latches on both ends of the memory connector.
4 Align the notches on the bottom of the card with the notches on the connector.
5 Push the memory card firmly into the connector until the latches on either end
of the connector snap into place.
It may require some force to fully seat the card.
6 Make sure each latch fits over the notch on the end of the card.
Latch
Notch
Connection points
What do I do now?
Task Go to page…
Installing a firmware card 22
Installing a hard disk 23
Installing an option card 24
Replacing the system board access cover 25