IBM UPS750TLV - Manual (Page 21)

17
Replacement part handling
If the issue cannot be resolved through any of the aforementioned steps, you will be sent a replacement
part. Pack the uninterruptible power supply or the faulty component in packaging sent by IBM, and use
the return label to ship back to IBM. Pack the uninterruptible power supply properly to avoid damage in
transit. Never use Styrofoam beads for packaging. Damage sustained in transit is not covered under war-
ranty.
Attention: Always DISCONNECT THE BATTERY before shipping. The battery can remain in
the uninterruptible power supply; it does not have to be removed.
Complete the following steps.
1. Shut down and disconnect any equipment attached to the uninterruptible power supply.
2. Shut down the uninterruptible power supply, and disconnect the uninterruptible power supply input
cord from the utility.
3. Disconnect the battery connector on the rear panel.