Intermec PX4I - Manual (Page 63)

EasyCoder PX4i User’s Guide (IPL version) 49
Chapter 6 — Setting Up the Printer
Default Setup
The printer’s default setup is listed below (no options included):
Ser-Com
Baud rate 9600 bps
Data bits 8 bits
Parity None
Stop bits 1 bit
Protocol XON/XOFF
Test/Service
Testprint not applicable
Data dump No
Memory reset not applicable
LSS Test not applicable
Media
Media type Gap
Paper type DT
Label length dots 1200 dots
Sensitivity 420
Darkness 0%
Label rest point 0 dots
Form adj dots X 0 dots
Form adj dots Y 0 dots
Ribbon low 0 mm
Paper low 0 mm
Confi guration
Power up emulation None
Print speed 5 in/sec
Cutter Not installed
Label taken sensor Not installed