Moxa Technologies C104H/PCI Series - Manual (Page 4)

About This Manual
This manual is composed of six Chapters and one Appendix. This manual is written for installer, system
administrator and software programmer.
If you are a first-time installer and system administrator, we recommend you to go through the whole
manual except Chapter 4 “Serial Programming Tools”.
If you are a software programmer, you may refer to Chapter 4 “Serial Programming Tools”.
If you need cable wiring information, please see Chapter 5 “Connection Cable and Cable Wiring”.
If you encounter any problem during installation, please refer to Chapter 6 “Troubleshooting”.
+ In this manual, C104H/PCI Series refers to C104H/PCI and C104HS/PCI.
Chapter 1 Introduction
This chapter gives the overview and features for C104H/PCI Series. Check list and overall installation
guide are also included.
Chapter 2 Hardware Installation
This chapter gives details of how to do hardware installation for C104H/PCI Series and connection cable.
Chapter 3 Software Installation
This Chapter describes the software installation, board and ports configuration, driver update and
removal for various operating systems: Windows NT, and Windows 95/98.
Chapter 4 Serial Programming Tools
This Chapter roughly describes the programming tools for various O.S. platforms, including P
PCCoom mm m Lite
under Windows NT and Windows 95/98.
Chapter 5 Connection Cable and Cable Wiring
This Chapter describes the RS-232 cable wiring for the connection cable.
Chapter 6 Troubleshooting
This Chapter describes error might happen and possible solutions for C104H/PCI Series.
Appendix Technical Reference
This chapter describes specification, PCI, UART and DB37 pinouts.