Marantz Model VP-10S1 - Manual (Page 41)

39
ENGLISH
7. Press the ENTER button to return to the menu and
disconnect the cable of the color temperature sensor from
the projector.
Note:
If color temperature adjustment is not correctly processed
or if adjustment processing is interrupted in course by
pressing the MENU button or for some other reason, the
below message appears on the screen.
Also, adjustment processing can be interrupted by pressing
the MENU button.
8. Reposition the picture on the screen (up, down, left and
right) using the “Lens shift” feature on the Config menu.
(See “Configuration”
☞
pg. 32.)
❖
Color Temperature Sensor Protection
If no operations are performed for approximately 10 minutes
from the moment color temperature adjustment processing
ends, power to the projector shuts off automatically in order
to protect the color temperature sensor. If power is shut off to
protect the color temperature sensor, do the following.
• If the WARNING indicator is not lit
When color temperature adjustment ends successfully and
the sensor protection feature trips, the projector goes on
standby. As usual, activate power by pressing either the
POWER ON button on the remote control or the POWER
button on the projector.
• If the WARNING indicator is lit
If color temperature adjustment does not end successfully
and the sensor protection feature trips, the projector’s
WARNING and STANDBY indicators light simultaneously
to indicate the error mode. Set the ON/OFF switch in the
off position, unplug the AC power cable and then plug it
back in. Then, set the ON/OFF switch in the on position
and press either the POWER ON button on the remote
control or the POWER button on the projector to reactivate
power.
If the lens becomes dirty or smudged, clean it with a soft
dry cloth and an optical lens cleaner that is approved for
eyeglasses or cameras. Do not use a dampened cloth,
detergent, thinner or other harsh substances. These
substances may damage the lens or leave stains. Do not
clean the lens while the lamp is on. Always shut off power
to the projector and wait at least 60 minutes before
cleaning the lens.
If replacement parts are needed, contact your nearest
Marantz dealer or authorized service center. Use only
replacement parts specified by Marantz. Unauthorized
substitutes may result in fire, electric shock or other
hazards, and will forfeit warranted servicing.
• Lamp unit : LU10VPS1
Optional Accessories
Replacement Parts
Lens Cleaning
Press "ENTER" to exit
Quit