Marantz Model VP-10S1 - Manual (Page 34)

32
ENGLISH
You can configure the projector from the following settings.
– Auto Power Off
When the auto power off feature is turned on, the below message appears on the screen if no signals are received and no
operations are performed for 9 consecutive minutes. Power to the projector then shuts off automatically if the situation
continues for another minute.
About 1 minute after the message appears on the screen, power to the projector shuts off.
Note:
After the above message appears on the screen, pressing any button on the projector other than the POWER button or any
button on remote controller other than the POWER ON or STANDBY button resets the auto power off feature. The auto power
off feature will start counting the time off any time after that, the moment that the projector goes without receiving any signals or
being operated in anyway.
– Installation
Sets the projector installation mode.
Front : Select this mode when the projector is installed on a flat surface in front of the screen.
F. Ceiling : Select this mode when the projector is mounted on a ceiling in front of the screen.
Rear* : Select this mode when the projector is installed on a flat surface behind the screen.
R. Ceiling* : Select this mode when the projector is mounted on a ceiling behind the screen.
* When projecting the image from behind the screen, use a rear-projection screen.
– Focus/Zoom
Adjusts the focus and size of the projected image.
– Lens shift
Positions (all directions) the projected image on the screen. (For details, see “Positioning the Projected Image”
☞
pg. 18.)
– Color Temp. Calibration
After replacing the lamp or otherwise when the lighting changes, you can adjust the color temperature using the color
temperature sensor. For instructions on how to adjust color temperature, see “Color Temperature Adjustment” (
☞
pg. 38).
– Reset Lamp Life
If you replace the lamp before the 1,500 hour lamp life, be sure to reset the lamp life counter. To do this, select “Reset Lamp
Life” from the Config menu. When you do so, the below message appears on the screen.
Select “Yes” and press the ENTER button. This will reset the lamp life counter.
Yes No
Reset Lamp Life
It will be standby mode soon.
Auto Power Off
Picture Adjust
Menu Standard 1
Setting
Display
System
Config
Trigger 2
Preset
Auto Power Off
Installation
Language
Focus/Zoom
Lens Shift
Color Temp. Calibration
Reset Lamp Life
Reset All
Disable
Front
English
Configuration
Auto Power Off Enable / Disable
Installation
Front, F.Ceiling, Rear, R.Ceiling
Language English, Français, Deutsch, Español,
Italiano, Português
Focus/Zoom Adjusts the focus and size of the projected
image.
Lens shift Positions (all directions) the projected
image on the screen.
Color Temp. Yes / No
Calibration
Reset Lamp Life Yes / No
Reset All
Yes / No