Moxi Version 4.1 - Manual (Page 67)

Media Center User Guide © 2006 by Digeo, Inc. All rights reserved.
Getting connected
60
This chapter details connecting the set-top box to your TV and other
home media equipment.
Before connecting
Before installing, the media center installation environment must meet
the following physical requirements:
• Locate the media center within six feet of a power outlet (do not
use an extension cord).
• Use a surge protector to isolate the media center from power
surges.
• Make sure the infrared receiver on the media center and the
remote are free from obstructions, such as furniture and doors.
Ventilation requirements
To prevent overheating, allow adequate ventilation and airflow around
the media center. The media center requires at least a two-inch (5 cm)
clearance on top and all sides with airflow to the or rear.
Figure 46: Ventilation requirements
If you have a multi-room media center and Moxi Mate, and are
moving either from their original installation room, a professional
cable installer must make a service call to configure your home’s
coaxial cable network.
If you have not already installed the
low-pass filter reflector, do it now. See Installing a low-pass
filter reflector
on page 15 .
!
Any Digeo set-top box
2 inches (5 cm)
2 inches
(5 cm) 2 inches
(5 cm)