Furuno LCD DISPLAY MU-155C - Manual (Page 9)

2
Flush mounting
See the outline drawing at the end of this manual for mounting dimensions.
CAUTION
Hold the hard cover and display unit
together when lifting the display unit.
The display unit may fall out if only the
hard cover is held.
1. Remove the hard cover from the unit.
2. Using the paper template supplied in the installation materials, make a cutout in the
mounting location.
3. Set the display unit to the cutout, and fasten it with four self-tapping screws (5X40,
supplied as accessories).
Note: Hex head bolts may also be used to fasten the display unit. However, their lengths
must be 10 mm longer than the wall thickness.
Waterproofing: IP20
Waterproofing: IPX5
30
130
Cosmetic cap
Minimum: 50
Mounting dimensions
4. Attach the cosmetic caps (supplied as accessories) to the display unit at the locations
shown in the drawing above.
5. Attach hard cover to protect the LCD.