Furuno LCD DISPLAY MU-155C - Manual (Page 23)

16
4.3 Choosing Source for Main Picture
Choose the signal to display on the entire screen as follows:
1. Press the [DISP] key to show the DISP selection window.
Signal names can be changed. For detail, see “3.3.2 Changing the signal name”.
DISP selection window
2. Press the [▲] or [▼] key to select a signal.
You can also select the signal by pressing the [DISP] key continuously.
RGB1-2:
The signal from the chosen RGB port is displayed on the entire screen.
DVI: The signal from the DVI port is displayed on the entire screen.
VIDEO1-3: The external video from the appropriate VIDEO port is displayed on the
entire
screen.
3. Press the [◄] or [►] key to close the window.
The window is erased when there is no operation within five seconds.
Note:
The name of the selected signal appears at the right top corner for five seconds after
the DISP selection window is erased.
RGB1
RGB2
DVI
VIDEO1
VIDEO2
VIDEO3