Furuno FR-2115-B - Manual (Page 41)

4-2
4. Connect the GYRO CONVERTER Board to the INT Board (cables supplied with GC-8) as
shown below.
INT Board GYRO CONVERTER Board
J446 (4P) J7 (5P)
J465 (6P) J1 (14P)
INT BOARD
03P9252
GYRO CONVERTER
BOARD 64P1106
J1
J5
J4
To gyro
J7
Fix cable to chassis
with cable tie.
J446
J465
Figure 4-2 Processor unit, inside view
5. Confirm gyrocompass specifications and set the DIP switches and jumper wires on the
GYRO CONVERTER Board according to the gyrocompass connected:
Setting jumper wires and DIP switches by gyrocompass specifications: page 4-4
Setting jumper wires and DIP switches by make and model of gyrocompass: page 4-5
Location of jumper wires and DIP switches: page 4-6
6. Solder the gyrocompass cable to the VH connector assemblies (supplied).
7. Attach instruction label (supplied) to shield cover for the INT and GYRO CONVERTER
boards.
8. Close both the INT Board cover and the processor unit cover.
9. Turn the power off and on again to reset the CPU.