Furuno SC-110 User Manual

Page 38

2. OPERATION

2-10

5. Choose SENTENCE and then press the [ENT] key.

DATA OUT1

HDT

VTG

VHW

HDM

GGA

VBW

ROT

GNS

HVE

ATT

GLL

ZDA

VDR

DATA OUT1 menu, sentences

6. Use the Omnipad to choose a sentence and then press the [ENT] key.

HDT: True heading (required for radar, AIS, ECDIS, etc.)
HDM: Magnetic heading (HDM is obtained in this equipment by adding the

magnetic variation to HDT.)

ROT: Rate-of-turn

data

ATT: True heading, pitching, rolling (FURUNO’s proprietary sentence)
VDR: Set and drift
VTG: Course over ground and ground speed
GGA: Global positioning system (GPS) fix data
GNS: GNSS fix data
GLL: Geographic position, latitude/longitude
VHW: Water speed and heading
VBW: Dual ground/water speed
HVE: GPS antenna up-down motion amplitude (FURUNO proprietary

sentence)

ZDA: Time and date

OFF

7. Use the Omnipad to choose OFF or ON as appropriate and then press the

[ENT] key. Sentences selected for output are marked with an asterisk.

8. Repeat steps 6 and 7 for other items. All sentences cannot be selected. The

message “SENTENCE OVERLOAD” appears when too many sentences
have been selected. Change settings as appropriate. For further information
see page 2-12.

9. Press the [MENU] key to return to the DATA OUT1 menu.
10. Choose BAUD RATE and then press the [ENT] key.

4800BPS

9600BPS
19200BPS
38400BPS

Baud rate options