Furuno RP180 - Manual (Page 27)

4. MARKS, LINES
4-4
4.2.2 Entering marks on the combination, video plotter displays
Marks can be entered on the combination and video plotter displays by cursor or at own
ship’s position.
Choosing mark type
1. Press the [MENU] key.
2. Press the [8] key twice to display the Mark menu.
3. Press the [1] key to choose Mark Selection.
4. Use the numeric keys to enter mark or line number desired.
5. Press the [ENTER/SELECT] key.
Note: To inscribe a new line, press the [1] key, key in line number (type) shown on the Mark
menu, press the [ENTER/SELECT] key, and the repeat steps 2 and 3. To inscribe
more than two of the same type of line, after completing a line, press [1] [2] [1] to
choose Erase Mark, press the [ENTER/SELECT] key and then press [1] to choose
line type.
Entering marks at cursor position
1. Choose mark desired as described in “Choosing mark type” above.
2. Place cursor on location where to inscribe a mark.
3. Press the [MARK] key.
4. Press the [MENU] key.
Entering marks at own ship’s position
1. Choose mark desired as described in “Choosing mark type” above
2. Press the [MARK] key.
3. Press the [MENU] key.