Hitachi C43-FL9000 - Manual (Page 41)

41
OTHER FUNCTIONS
ASPECT MODE
˄The function shown as below is designed for the C43-FL9000 model.˅
1.When non HD component signal is received
You may set different aspect modes to view the image with different signal formats.
You can change between four different modes, lj4:3NJ, lj4:3 ZoomNJ,lj16:9NJandlj16:9 ZoomNJ.
Please see the following on each of four modes for details.
ƽTo switch aspect mode, please press the P.SIZE button, the TV will display the corresponding aspect mode
momentarily on the lower part of the screen. For example, set the current aspect mode to lj4:3NJ as shown on
the lower left side. If lj4:3 ZoomNJ is set as shown on the lower right side, you can press the ŸP+ źP-
cursor buttons to adjust the display position up and down before the words Ālj=RRPNJ6FUROOā
disappears as shown on the lower right side.
`
2.When HD component signal is received
Press the P.SIZE button to switch between two different modes, lj16:9NJandlj16:9ZoomNJ.
Remark:
If you change program No. or power on the TV, the aspect mode will return to the mode of
lj16:9NJ(when HD
signal is received ) or lj4:3NJ(when conventional signal is received).
Notes ˖
1 ˊ Do not watch TV at non full screen, as this may cause damage to your PRT.
2 ˊ Using this special function (aspect mode) to change the size of image displayed (i.e., change the ratio of
height and width) for the purpose of public release or some commercial interests may infringe the
copyright law.
3 ˊ In multi picture, pressing the P.SIZE button does not function.
ljNJ
Signal sources
ljNJ
lj=RRPNJ
ljNJ
Suggested
aspect
mode
lj=RRPNJ
lj=RRPNJ6FUROO
For example:
Conventional TV
broadcast format For example:
signal transformed
from HD For example:
16:9 widescreen cinema